Sensors
This dataset contains heavy-machinery data from the Brazilian industrial sector. The data was collected in a poultry feed factory located in the state of Minas Gerais, Brazil. Its process can be summarized to creating pellets of ration for poultry from corn or soybeans and added nutrients. The factory produces at fullscale over the entire year, thus it has well-behaved usage patterns at any time. It operates from Mondays through Fridays (and occasionally on Saturdays, in case production is below the monthly target) on a daily three-turn shift from 10:00 PM to 05:00 PM.
- Categories:
7367 Views
This work quantifies water contamination in jet fuel (Jet A-1), using silica-based Bragg gratings. The optical sensor geometry exposes the evanescent optical field of a guided mode to enable refractometery. Quantitative analysis is made in addition to the observation of spectral features consistent with emulsification of water droplets and Stokes’ settling. Measurements are observed for cooling and heating cycles between ranges of 22oC and -60oC. The maximum spectral sensitivity for water contamination was 2.4 pm/ppm-v with a resolution of < 5 ppm-v.
- Categories:
207 Views
This work quantifies water contamination in jet fuel (Jet A-1), using silica-based Bragg gratings. The optical sensor geometry exposes the evanescent optical field of a guided mode to enable refractometery. Quantitative analysis is made in addition to the observation of spectral features consistent with emulsification of water droplets and Stokes’ settling. Measurements are observed for cooling and heating cycles between ranges of 22oC and -60oC. The maximum spectral sensitivity for water contamination was 2.4 pm/ppm-v with a resolution of < 5 ppm-v.
- Categories:
88 Views
The original data set is from the official website of NASA, the four bearings operation data of the 2nd in IMS data set were used in article experiment.
- Categories:
212 Views
The original data set is from the official website of NASA, the four bearings operation data of the 2nd in IMS data set were used in article experiment.
- Categories:
513 Views
DECA is widely used as a protocol to describe the fuel economy and battery load of vehicles. Meanwhile, Carsim is universally accepted as a reliable tool to analyze vehicle dynamics. Therefore, it is of great importance to simulate the DECA with Carsim and provide a proper way to measure the virtual fuel economy of vehicles. It may also contribute to explement related experiments.
- Categories:
453 Views
The Geomagnetic field can be used for classifying different landmark locations inside a big building.
- Categories:
465 Views
There are two types of data: raw EEG data recorded from the Brain-Vision system and Mat file converted by BBCI-Tool Box.
- Categories:
257 Views
The data set contains 360 instances of images of transparent PET preforms with a constant actual color. The measured color is varring because of illumination conditions. The measured color variation factor is described as color value correction coeficient.
- Categories:
134 Views
Videomicroscopic Semi-Shadow Visualization of LoC-Si (Lab-on-a-Chip_[based_on]_Silicone) test structures from Institute of Molecular Electronics (D. Shevchenko; founder of Scientific and Production Association "Microbiotechniques" Ltd.) and Russian Academy of Sciences (INEPCP RAS; ICP RAS)
Vis. Tech.: MBS-10 Binocular Stereoscopic Microscope; Indirect Angular Illumination.
Found.: Initiative project (D. Shevchenko, O. Gradov; 2015-2016)
Fab.: JSC “Voskhod” KRLZ*
- Categories:
204 Views