Calibration
Calibration comparison data, including data obtained by calibrating the large deformation sensor using the proposed calibration device suitable for large deformation six-dimensional force sensors, and data obtained by calibrating the same large deformation six-dimensional force sensor using the calibration device suitable for high rigidity six-dimensional force sensors.
- Categories:
289 Views
The scintillator detectors are recalibrated against the datasheet given by the manufacturer. Optimal and mutual dependent values of (a) high voltage at PMT (Photomultiplier Tube), (b) amplifier gain, (c) average time to count the radiation particles (set by operator), and (d) number of instances/sample number are estimated. Total 5: two versions of Central Limit Theorem (CLT), (3) industry preferred Pulse Width Saturation, (4) calibration based on MPPC coupled Gamma-ray detector, and (5) gross method are used.
- Categories:
30 Views
Blood pressure (BP) measurement is an indispensable parameter for diagnosing many diseases, e.g., heart attack, stroke, vascular disease, and kidney disease. All these disease sometimes lead to fatal injuries due to the failure of vital human organs. The measurement of BP using BP device has several inaccuracies due to the non-availability of SI traceable calibration systems, which can also meet the criteria of International Organization of Legal Metrology (OIML) particularly OIML R 148 and OIML R 149 guidelines.
- Categories:
97 Views
Reverberation chamber (RC) is a metal cavity which is often used for EMC measurements. During the last couple of decades, RC has proved to be a useful tool for Over-the-air (OTA) measurements such as antenna efficiency, diversity gain, etc. A well stirred RC produces Rayleigh fading environment which is considered as a common test environment for testing and simulating performance of wireless devices such as mobile phones in GSM, WCDMA, UMTS and LTE frequency ranges.
- Categories:
150 Views
The data and codes show 3D reconstruction of a checkerboard with pseudo-colored errors, using different calibration and reconstruction methods. (1) with general stereo calibration and linear reconstruction, (2) with general stereo calibration and approximately undistorted reconstruction, (3) with stereo calibration and undistorted reconstruction using nonlinear epipolar constraints, and (4) with the residual distortion-calibrated reconstruction.
- Categories:
451 Views
This data is mainly used for the calibration of the long-stroke Cartesian robot. The position data is measured by Leica Laser Tracker, including the data of the identification of kinematics parameters, the data of the Gaussian process regression model validation and prediction, and the data that the compensation results based on HTM, HTM+SBD, HTM+GPR, HTM+SBD+GPR model in different position points.
- Categories:
159 Views
The data are used to identify the kinematic parameters deviation of Cartesian robot, train Gaussian Process Regression (GPR) model, record the compensation result of four calibration methods under different loading conditions.
- Categories:
143 Views
Calibration datasets used in the article Standard Plenoptic Cameras Mapping to Camera Arrays and Calibration based on DLT. These datasets were acquired with a Lytro Illum camera using two calibration grids with different sizes: 8 × 6 grid of 211 × 159 mm (Big Pattern) with approximately 26.5 mm cells, and 20×20 grid of 121.5 × 122 mm (Small Pattern) with approximately 6.1 mm cells. Each dataset acquired is composed of 66 fully observable poses of the calibration pattern.
- Categories:
813 Views