reliability

The dataset includes on-state saturation voltage information for eight samples under four different test conditions.  Each Excel file consists of two data columns: one for cycle numbers and the other for on-state saturation voltage. Although these data were collected during the power cycling test at the maximum junction temperature, the effect of temperature increase in the on-state voltage has been compensated. Namely, the provided on-state voltage has been unified to the corresponding to the respective 125°C or 150°C.

Categories:
444 Views

Distribution test systems with 24, 54, 86, and 136 nodes, which can be used for distribution system reliability evaluation. All these Networks are medium-voltage (MV) distribution grids.

Categories:
621 Views

Performance of Wireless Sensor Networks (WSN) based on IEEE 802.15.4 and Time Slotted Channel Hopping (TSCH) has been shown to be mostly predictable in typical real-world operating conditions. This is especially true for performance indicators like reliability, power consumption, and latency. This article provides and describes a database (i.e., a set of data acquired with real devices deployed in a real environment) about measurements on OpenMote B devices, implementing the 6TiSCH protocol, made in different experimental configurations.

Categories:
2914 Views

Test networks for reliability-based distribution studies.

This dataset includes 5 test netwroks with 37, 85, 137, 145, and 230 nodes.

Categories:
316 Views

The aircraft fuel distribution system has two primary functions: storing fuel and distributing fuel to the engines. These functions are provided in refuelling and consumption phases, respectively. During refuelling, the fuel is first loaded in the Central Reservation Tank and then distributed to the Front and Rear Tanks. In the consumption phase, the two engines receive an adequate level of fuel from the appropriate tanks. For instance, the Port Engine (PE) will receive fuel from Front Tank and the Starboard Engine (SE) will receive fuel from Rear Tank.

Categories:
1885 Views

Experiments are conducted on a polishing industrial robot using the CompuGauge robot performance analysis system. The aim of this experiment is to explore the influences of link dimension errors and joint torsional angle errors on the positional accuracy reliability for single coordinate, single point, multipoint and trajectory accuracy of industrial robots.

Categories:
356 Views