Communications
More than 85% of traffic utilization via mobile phones are consumed in the urban area, and most of the traffic is used for downloading. Improving the throughput in LTE for 1 user equipment (UE) in cities is an urgent problem. The collected data is intended to study a dependence of the KPI mobile base station and neighboring from installation extra technology. This study will support the development of methods for comparing traffic utilization of urban area and carry out recommendations for the Channel Quality Indicator (CQI) increases.
- Categories:
498 Views
Transistor models are crucial for circuit simulation. Reliable design of high-performance circuits requires that transistor characteristics are adequately represented, which makes accurate and fast models indispensable. Scattering (or S-)parameters are perhaps the most widely used RF characteristics, employed in the design and analysis of linear devices and circuits for calculation of the input and output impedance, isolation, gain, as well as stability, all being important performance figures for small-signal or low-noise amplifiers.
- Categories:
145 Views
These are the three figures used in this article
- Categories:
2 Views
Good knowledge about a radio environment, especially about the radio channel, is a prerequisite to design and operate ultra-reliable communications systems. Radio Environment Maps (REMs) are therefore a helpful tool to gain channel awareness. Based on a user’s location, the channel conditions can be estimated in the surrounding of the user by extracting the information from the radio map. This data set contains two measured high-resolution REMs of an indoor environment.
- Categories:
664 Views
This dataset is used for the identification of video in the internet traffic. The dataset was prepared by using Wireshark. It comprises of two types of traffic data, VPN (Virtual Private Network) or encrypted traffic data and Non-VPN or unencrypted traffic. The dataset consist of the data streams (.pcap) of 43 videos. Each video is played 50 times in both VPN and Non-VPN mode. The streams were obtained by setting-up a dummy client on a PC which plays a YouTube video and Wireshark is used to capture the internet traffic.
- Categories:
1170 Views
This letter presents a random forest regression (RFR)-based adaptive power allocation (APA) scheme to predict an optimized power factor for user's fair access to data rate in a downlink mmWave non-orthogonal multiple access systems. Notably, the proposed APA scheme learns from the sum rates dataset associated with both distance and inverse pathloss (power factor optimization) models to predict optimized power factors with respect to average value approach.
- Categories:
36 Views
Millimeter-wave (mmWave) spectrum with wide bandwidth provides a promising solution to enable high throughput in next-generation wireless agricultural networks, characterized by swarms of autonomous ground vehicles, unmanned aerial vehicles (UAVs), and connected agricultural machinery. However, channel models at mmWave frequencies in agricultural environments remain elusive. Moreover, agricultural field channels bear notable distinctions from urban and rural macrocellular network channels due to the dynamic crop growth behavior.
- Categories:
695 Views
This work aims to identify anomalous patterns that could be associated with performance degradation and failures in datacenter nodes, such as Virtual Machines or Virtual Machines clusters. The early detection of anomalies can enable early remediation measures, such as Virtual Machines migration and resource reallocation before losses occur. One way to detect anomalous patterns in datacenter nodes is using monitoring data from the nodes, such as CPU and memory utilization.
- Categories:
743 Views
This dataset has been used to evaluate different consistent hashing algorithms for non-peer-to-peer contexts. Further information can be found at https://github.com/SUPSI-DTI-ISIN/java-consistent-hashing-algorithms
- Categories:
114 Views