Power and Energy
RSSI-Dataset
The RSSI-Dataset provides a comprehensive set of Received Signal Strength Indication (RSSI) readings from within two indoor office buildings. Four wireless technologies were used:
- Zigbee (IEEE 802.15.4),
- WiFi (IEEE 802. 11),
- Bluetooth Low Energy (BLE) and
- Long Range Area-Wide Network (LoRaWAN).
For experimentation Arduinos Raspberry Pi, XBees, Gimbal beacons Series 10 and Dragino LoRa Shield were also used.
- Categories:
1847 Views
This is the data for the grounding current of a radial structured distribution network, when subject to a single-phase earth fault.
- Categories:
180 Views
Research on Optimizing the Integration of Renewable Energy Sources into the Electrical Power Systems
In this project one model the photovoltaic and wind power sources in order to analyze how to optimally integrate them in the electrical power systems. Integration requirements like transient regimes associated with fault occurrence, identification of the electrical power systems responsible for disturbances, and optimization of the integration are focus points of the research.
- Categories:
945 Views
This is the Smulation Data for Power System State Estimation.
- Categories:
546 Views
This dataset contains the numerical results and Excel graphing used to create the results images in the main paper.
- Categories:
359 Views
Advances in Wireless Sensor Network Technology (WSN) have provided the availability of small and low-cost sensor with capability of sensing various types of physical and environmental conditions, data processing and wireless communication. In WSN, the sensor nodes have a limited transmission range, and their processing and storage capabilities as well as their energy resources are limited. Triple Umpiring System (TUS) has already been proved its better performance on Wireless Sensor Networks. Clustering technique provides an effective way to prolong the lifetime of WSN.
- Categories:
961 Views
This work presents a novel Anti-Islanding (AI) protection of Photovoltaic (PV) Systems based on monitoring the dc-link voltage of the PV inverter. A PV System equipped with AI protection like frequency relays, a rate of change of frequency (ROCOF) relay, and respectively the proposed dc-link voltage relay is simulated under the conditions of islanding and the detection time for all these AI techniques are compared. The study shows under which conditions our proposed dc-link voltage AI relay is the most efficient.
- Categories:
2487 Views
This work presents a Matlab/Simulink study on anti-islanding detection algorithms for a 100kW Grid-Connected Photovoltaic (PV) Array. The main focus is on the islanding phenomenon that occurs at the Point of Common Coupling (PCC) between Grid-Connected PV System and the rest of the electric power system (EPS) during various grid fault conditions. The Grid-Connected PV System is simulated under the conditions of islanding, and anti-islanding (AI) relay reaction times are measured through the simulation.
- Categories:
2182 Views
This work aims to implement in Matlab and Simulink the perturb-and-observe (P&O) and incremental conductance Maximum Power Point Tracking (MPPT) algorithms that are published in the scientific literature.
- Categories:
3361 Views