Extrusion deformation - time data
- Citation Author(s):
-
jun liu
- Submitted by:
- jun liu
- Last updated:
- DOI:
- 10.21227/12k6-7v48
- Data Format:
5 views
- Categories:
- Keywords:
Abstract
According to GB/T 31467.3-2015, the Battery Enclosurewith Modules is placed on a test bench, Cylinders as extrusionmoving parts, to conduct extrusion tests in the X and Y directions. The extrusion is stopped when the extrusion forcereaches 200 kN or the deformation rate reaches 30%. During this process, the interior of the battery module is observed for any damage.
Instructions:
Graphs can be drawn based on the data to view the magnitude of the deformation and the speed of the response time
Funding Agency
Open Project of National Key Laboratory of Land and Air Based InformationPerception and Control, China
Grant Number
B324009
