Wireless Networking

This 5G dataset that can be used to advance research in attack detection in 5G service based architecture was generated using the open-source Free5GC testbed and UERANSIM, a UE/RAN simulator. The dataset include benign traffic featuring 5G procedures (e.g., registration, deregistration, PDU session establishment/release, uplink, downlink) along with 6 different HTTP/2 attack simulated between different 5G network functions. including:

Categories:
465 Views

This dataset is supplementary materials for "Study and Implementation of VLC with Angular Diversity Receiver for IoT Systems".

1. ADR Demonstraion.mp4

This describes the prototype of the ADR for IoT systems. It starts from the introduction of the prototype to the demonstration.

Real-time sensor data transmission is demonstrated. The monitor shows the light sensor value at the access point and the user node.

2. Mobile suitability Demonstration.mp4

Categories:
601 Views

 This paper includes a variety of media location data generated in the paper.According to the wideband near-field signal propagation model, sample data were generated based on four layers of media with known media types. The main differences between simulated data and real data are errors due to electromagnetic dispersion, multipath and noise, which are not currently taken into account because of different electromagnetic characteristics in inhomogeneous media. The setting of condition variables in the experiment was shown in Table I.

Categories:
805 Views

This work provides an in-depth analysis of the

Listen-Before-Talk (LBT) procedures that cellular technologies

must adhere to for operation in the unlicensed spectrum. In par-

ticular, we provide detailed insights into the 5G New Radio Un-

licensed (NR-U) standalone design according to the latest 3GPP

standard-compliant Type 1 Channel Access Procedure (CAP).

We highlight some of the challenges and propose improved

mechanisms for channel access. We carry out the performance

Categories:
125 Views

Wireless Sensor Networks (WSNs) are self-organizing wireless networks comprising a large number of wireless sensors. Consequently, WSNs represent a potential method for providing communication in areas where the communication infrastructure has been severely damaged.

Categories:
236 Views

The dataset is built upon a multi-layer multi-domain (MLMD) network topology of a real testbed.

Categories:
390 Views

Phase noise is a common hardware impairment, resulting from the frequency instability of voltage-controlled oscillators (VCO). To improve the phase noise performance of a VCO, they are typically connected to a control circuit. This control circuit is known as phase locked loop (PLL). It is commonly used as a frequency synthesizing circuit for the carrier frequency in mobile communication transceivers. Universal Software Radio Peripherals (USRP) are widely used in mobile communication research.

Categories:
263 Views

This document provides the values of the channel parameters to help reproduce the results of Fig. 13 of "Practice and Evaluation for Ceiling-Mounted MIMO Indoor Base Stations with Antenna Optimization and SAR Touch Compliance" submitted to IEEE Transactions on Antennas and Propagation. In the indoor-office scenario, when the UE (Rx) and BS (Tx) are located at (5m, 5m, -2m), (0m, 0m, 0m) respectively, the line of sight (LOS) zenith angle of departure (ZOD) is 105.79°, and the LOS azimuth angle of departure (AOD) is 45°.

Categories:
73 Views

The data repository contains data sets obtained with Quantum-approximate optimization algorithm (QAOA) simulations and experiments for the main article in [1]. For a comprehensive understanding, please check readme_qaoa_mvsic.pdf file and refer to the main article in [1]. We design, theoretically model, simulate and experiment QAOA-MVSIC algorithm combining QAOA, majority voting (MV) and successive interference cancellation (SIC) to target experimental challenges of QAOA for maximum-likelihood (ML) decoding for n × n massive multi-input multi-output (MIMO) systems with large n.

Categories:
337 Views

This dataset has been collected from both User Equipment (UE) and Network sides. UE side metrics consist of radio metrics that have been merged with localization information from the modem. Network side metrics consist of network Key Performance Indicators (KPI).

The dataset contains both stationary and movement samples for different approaches. Beamforming information is available from the serving and up to 3 neighbouring beams.

Categories:
244 Views

Pages