Meshes of Various Design and Deformation

Citation Author(s):
Michael Joon Seng
Goh
Monash University Malaysia
Ji Jinn
Foo
Monash University Malaysia
Yeong Shiong
Chiew
Monash University Malaysia
Submitted by:
Michael Joon Se...
Last updated:
Tue, 11/19/2019 - 07:39
DOI:
10.21227/xyaz-gj62
Data Format:
License:
0
0 ratings - Please login to submit your rating.

Abstract 

Stereolithographic files of three different mesh designs; Square, Triangular and Hexagonal (top to bottom rows in image). Each mesh design is provided in three different deformations; Flat/no deformation, Mode 1 deformation and Mode 5 deformation (left to right columns in image). Mode 1 and Mode 5 deformation was obtained by modal study with the four outer surfaces of the frame fixed. Note that the out-of-plane deformation has been scaled to better proportions.

Instructions: 

Each STL file contains one of the meshes at a particular deformation.

The files are labelled according to the following convention:

 

Mesh_"Mesh Design"_"Deformation".STL

Where

"Mesh Design" can be "Square" for the square mesh, "Tri" for the triangular mesh and "Hex" for the hexagonal mesh.

"Deformation" can be "Flat" for no deformation, "Mode 1" for mode 1 deformation and "Mode 5" for mode 5 deformation.