Dataset for Identification of Saturated and Unsaturated Wi-Fi Networks
- Citation Author(s):
- Submitted by:
- Merkebu Girmay
- Last updated:
- Tue, 05/16/2023 - 16:03
- Data Format:
- Research Article Link:
Dataset for Identification of Saturated and Unsaturated WiFi Networks
The Dataset comprises the histogram of Inter-frame spacing for saturated and unsaturated WiFi networks.
In order to develop a CNN model that can classify saturated and unsaturated traffic in WiFi network, we prepared a large dataset that represents the traffic characteristics of both cases.
In order to develop a CNN model that can classify saturated and unsaturated traffic in WiFi network, we prepared a large dataset that represents the traffic characteristics of both cases. In this dataset collection, different scenarios of saturated and unsaturated 802.11a network are modelled in ns-3. A Wi-fi network is distinguished as saturated network if its aggregated throughput has reached the maximum system throughput limit Different saturated and unsaturated network scenarios were generated by varying the packet arrival rate (PAR) and number of active nodes. The PAR is tuned below and above a grey region of saturation point for saturated and unsaturated networks respectively. Once the PAR of saturation point for a specific network configuration is determined to be PARsat, the grey region is defined when the PAR lies between PARsat − 250packet/s and PARsat + 250packet/s. UDP traffic was generated at different packet arrival rates to investigate the traffic characteristics of different load levels covering a wide range of performance variations in saturated and unsaturated traffic cases. For each configuration and traffic load examined in this study, the simulation run-time was set to 20 minutes. Then, the starting time and duration of each frame accessing the medium is monitored to generate the IFS distribution and collision percentage.
Each element E in a row of the dataset is obtained by monitoring IFS and percentage of collision and is composed of (x1, x2, ..., x26, y1, y2, ..., y26, s, r, l). The values fx1, x2..., x26, y1, y2, ..., y26 represent the histogram of the IFS values for the M frames that accessed the medium in 60 seconds duration. x26 represents the maximum IFS duration (in ms) in the considered M frames whereas x1 is x26/26. The remaining xi values are buckets at uniform spacing between x1 and x26. For i>1, the values of yi represent the IFS histogram count (in percentage) for a corresponding bucket interval between xi-1 and xi. In the case of y1, the bucket interval is between 0 and x1. The s and r in the sequence of the dataset element represent the average IFS duration (in ms) and percentage of frame collisions respectively. The average IFS duration is computed by averaging the IFS between each frame in the dataset element over the total number of frames. Similarly, the collision percentage is computed by counting the frames that are not acknowledged (if no corresponding ACK frame is received by the transmitter). The last parameter in the data set element is l which represents the labeling. Labels "1" and "0" represent saturated and unsaturated Wi-Fi networks respectively. Based on this approach, 20,000 sample elements are collected with a more or less equal portion of saturated and unsaturated traffic scenarios. Figure below shows dataset samples form saturated and unsaturated networks.
- Dataset for saturated and unsaturated Wi-Fi Saturated_Unsaturated_Wi-FI_dataset.zip (1.69 MB)
- Source code for saturation sensing model code_wifi_saturation_sensing_model.zip (16.16 MB)